The contents of the Preferred DNS Server if you do not have a special root server only from indihome can be filled with the same as the Default gateway.Fill in the Default Gateway from the Indihome Rooter or the rooter you have with IP number 1.Fill in the IP Address that has been determined according to the quota of each client.If you use a cable then select the Ethernet right click select Properties. then select Internet Protocol Version 4 (TCP/IPv4) > Select Properties, and a new window will appear as shown in the image below.Select change adapter setting then the Ethernet and Wi fi network names will appear. ![]() Please go to Control Panel / Settings > Network and Sharing Center settings to configure server or client computers.Specify an internet IP Gateway as a bridge to connect to the internet, for IP Gateway on telecom indihome usually 192.168.100.1 without this IP gateway you will not be able to connect to the internet. ![]() You must specify a Static IP for the server so that it can be accessed by the client. The first setting is on the server computer and Rooter.Make sure the Ethernet Driver is installed correctly.Here is the Local Area Network Settings to Connect between Server and Client: In order for the networking network to be connected and connected, the correct settings must be made. To connect or build a local area network, settings are needed because networking involves several hardware such as Server, Rooter, Hub or connection, and Client / Computer user. If the hardware has been confirmed to be in a normal state and installed correctly then you must follow the next steps which will be discussed in the section below. Make sure the LAN Card is installed correctly, if the Lan Card is on board check the socket is still good whether there is dirt or corrosion.Make sure the RJ45 cable is arranged according to the LAN groove, to make it easier to check, use a special tool to check the RJ45 LAN cable.Make sure the RJ45 cable you use to connect the LAN network is of good quality. A good LAN cable is made of copper wire, not copper fiber.Here are the sections or settings that you should check first: #1. ![]() There are several causes that make Network Cable Unplugged, so you must analyze them first in order. What Causes Network Cable Unplugged / Internet network is not connected?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |